Does the hot wire go on the top or bottom of a switch?

Is it on the top or bottom of the switch – Quora. If you are speaking of a single pole switch, doesn’t matter. On a 2 pole switch, box mounted, technically it doesn’t matter, but good practices are line at the top, load at the bottom. If a disconnect switch, always line at the top, load at the bottom.

What is the difference between socket switch and lighting switch?

The parts of the typical domestic light switch are very similar to the parts of the socket although a switch is designed to interrupt the follow of electricity to a light so you can turn it off.

What are the electricity switches called?

circuit breakers
In an electric power system, switchgear is composed of electrical disconnect switches, fuses or circuit breakers used to control, protect and isolate electrical equipment. Switchgear is used both to de-energize equipment to allow work to be done and to clear faults downstream.

Why would you use a double pole switch?

Double pole light switches, also known as a four-way switch, are two single pole switches put together. This is typically used to control a circuit from multiple locations in a series of three switches on one circuit. A double pole switch can be used to control light and a fan or 2 lights on separate circuits.

What is a push button switch?

A Push Button switch is a type of switch which consists of a simple electric mechanism or air switch mechanism to turn something on or off. Depending on model they could operate with momentary or latching action function. This means that when a button is pressed it can cause another button to release.

Where does the white wire go on a light switch?

The white (neutral) wire connects to the silver screw, or you place it in the back wire hole on the same side of the device as the silver screw. The black (hot) wire goes to the brass screw or into the hole in the back of the device on the same side as the brass screw. This wire is sometimes red.

Why is there two black wires in light switch?

STEP 3: Identify the terminal and ground wires. You should see two black wires, each connecting to a different screw on the side of the switch. These are called terminal screws. These are ground wires.

When did Decora switches come out?

1973
From the first Decora switch introduced in 1973 to a full collection of products today, Decora has set the industry standard by enhancing home décor with distinctive style and superior performance.

Which way should a light switch turn on UK?

Orientation. The direction which represents “on” also varies by country. In the US, Canada, European countries, Russia, etc., it is usual for the “on” position of a toggle switch to be “up”, whereas in many other countries such as the UK, Australia, New Zealand (Commonwealth countries) and Ireland, it is “down”.

Why is it called switchgear?

The combination of circuit or fuses, electrical disconnects switches or breakers used to isolate, protect and control electrical equipment or gears from the defective condition are usually called switchgear.

Can I replace a double pole switch with a single pole switch?

There are two different types of switches: the single pole and the double pole switch. A double pole switch can be used to control light and a fan or 2 lights on separate circuits. It is easy to wire a double pole switch to work as a single pole switch because only one side is used instead of both.