How much can I plug into a 20 amp outlet?

10 receptacles
One rule of thumb is to assign a maximum draw of 1.5 amps to each receptacle, which allows for 10 receptacles on a 20-amp circuit.

How much can a 20 amp breaker handle?

A 20-amp breaker can support up to 2,400 watts on a single circuit. The safe maximum for a 20-amp circuit is 1,920 watts, but circuits should not be loaded to more than 80 percent of their maximum capacity.

Is 20 amps enough for a garage?

As a general guideline, you’d use 12 AWG copper conductors with a 20 ampere breaker, and 14 AWG copper conductors with a 15 ampere breaker. Since the receptacles are in a garage, they’ll have to be GFCI protected.

What amperage receptacles are allowed on a 20 amp individual branch circuit?

The maximum number of receptacles permitted on a 20-ampere, 120-volt breaker is 13 (see Figure 5). In accordance with Tables 210.21(B)(3) and 210.24, these receptacles can be 15-ampere, 20-ampere or any combination thereof.

How many watts can I run on a 20 amp circuit?

2,400 watts
20-amp 120-volt circuit: 20 amps x 120-volts = 2,400 watts.

How far can you run 12 gauge wire on a 20 amp circuit?

Originally Answered: How far can you run 12 gauge wire on a 20 amp circuit? About 400 feet. After that voltage drop is a factor and the gauge will have to be increased or the voltage increased.

Do I need GFCI outlets in garage?

GFCI protection is required for 125-volt to 250-volt receptacles supplied by single-phase branch circuits rated 150 volts or less to the ground. GFCI receptacles are required in bathrooms, garages, crawl spaces, basements, laundry rooms and areas where a water source is present.

What wire do you use for 20 amps?

A 20-amp circuit, protected by a 20-amp breaker or fuse, must be served by 12-gauge or 10-gauge wire.

Can you put lights and outlets on the same circuit?

Basic answer to your question of can a mixture of lights and receptacles be installed on a single circuit is yes.

Can I daisy chain electrical outlets?

Electrical receptacles have two pairs of terminals so that you can daisy-chain multiple receptacles on a single circuit in an existing house.

How many wires can you connect to an outlet?

1 Answer. The receptacle manufacturer should document how many wires can be put where. In general, if there are screws, you can use at most one wire per screw. For quickwire/backwire holes, you can only use one wire per hole, and further, that one wire can only be 14 gauge.