Where should toilet supply line be placed?

Insert the line through the bottom plate on the wall, approximately 8 inches to the left of the toilet’s center line. Connect this supply line at the water line attached to the sink.

How far off wall should toilet supply line be?

Standard drywall is 1/2 inch thick, so the plumber should set the toilet flange at least 15-1/2 inches from the center of the flange to the wall framing. The standard distance from the back wall is 12 inches, or 12-1/2 inches from the center of the flange to the wall framing.

Can you replace a 12-inch rough-in toilet with a 10 inch rough-in toilet?

A toilet with a 12-inch rough-in will definitely not fit into a space with a 10-inch rough-in, but a toilet with a 10-inch rough-in actually has extra space in a 12-inch rough-in space.

What does 12 rough-in mean for toilet?

The toilet rough-in refers to the distance from the finished wall to the center of the toilet’s floor drain or waste outlet. Most toilets have a rough-in of 12 inches, although it’s not uncommon for older homes to have an unusual size such as 10″ or 14″. Rear-outlet toilets are configured a bit differently.

How many inches apart should water supply lines be installed?

Hot and cold water lines should be approximately 6 inches apart unless the hot water line is insulated. This is to ensure that the cold water line does not pick up heat from the hot water line [2]. The supply mains should have a drain valve stop and waste valve to remove water from the system for repairs.

Why is my new toilet so far from the wall?

When toilet flanges are installed it is typically in the early stages of the project and the standard 12″ measurement is taken from the drywall, rather than the finished tile surface that you are measuring from. That means your flange was set at a distance further from the wall than even the 13″ you measured.

Why would I want an elongated toilet bowl?

Elongated bowls are also considered more ‘hygienic’ in that the larger surface area of the bowl makes is easier for men and children to use with less mess. The longer bowl size is also a requirement for ADA use, and the longer/wider bowl is generally easier to use for those with mobility issues.

How do I make sure my new toilet will fit?

If the base of the new toilet is shorter than the distance between the rear bolt holes and the wall, it should fit. In small bathrooms where space is tight, also measure from the sides of the flange bolts to the sidewalls or other objects to assure side-to-side clearance.

Can you replace a 10-inch rough-in toilet with a 12-inch rough-in toilet?

The rough-in for your bathroom plumbing should match the rough-in for the toilet. Even if a toilet is designed for a 10-inch rough-in, you can still install it in a space with a 12-inch rough-in.

How do I know if my toilet is a 10 or 12 rough?

If your toilet has four bolts rather than the standard two, you’ll measure to the center of the rear bolts. The standard rough-in measurements are 10, 12 and 14 inches. If your measurement is in between these intervals, round your number down to the nearest standard measurement.