Why does my G35 turn off while driving?

Stalling occurs because at the time the problem occurs, the engine stops getting something it needs to keep running. Either fuel stops being delivered, ignition spark ceases, or air flow in and out of the engine is too much or too little for what is needed. You could also have an electrical power issue.

How do I reset my Infiniti G35?

Get into Your vehicle and turn the ignition switch to the ON position, You do not need the ignition key inside Your fob for this step. Push down on Your gas pedal firmly and then fully release it. Repeat this procesS5 times, making sure to distinctly release and depress each time.

How do you reset the ECU on a 2007 Infiniti g35?

1. Make sure that the accelerator pedal is fully released.
2. Turn ignition switch “ON” and wait at least 2 seconds.
3. Turn ignition switch “OFF” wait at least 10 seconds.
4. Turn ignition switch “ON” and wait at least 2 seconds.
5. Turn ignition switch “OFF” wait at least 10 seconds.

How do I know if my starter is bad?

One of the symptoms of a bad starter is a clicking noise when you turn the key or push the start button. However, a starter can die without making any sound at all, or it may announce its impending death with whirring and grinding noise—so listen up!

Where is the starter on a 2007 Infiniti?

There is a under engine shield that must be removed , it is at the passenger side rear of the engine and is removed from below.

What are the symptoms of a bad camshaft sensor?

If your vehicle idles roughly, stalls frequently, has a drop in engine power, stumbles frequently, has reduced gas mileage, or accelerates slowly, these are all signs your camshaft position sensor could be failing.

How do you know when a camshaft sensor is bad?

A glowing check engine light, stalling, poor acceleration and bad fuel mileage are all possible signs your camshaft position sensor may be failing. Gone are the days of carburetors and distributors, replaced by a variety of sensors that help a car’s computer get the maximum performance out of the engine.

What causes service engine soon light?

The Check Engine/Service Engine Soon light comes on when there is an emissions, ignition, fuel system or transmission related failure. This light does not mean that you just need routine maintenance. There are many different failures that may cause this light to come on. If the light is flashing, this is more serious.

What are some of the problems with the 2007 Infiniti G35?

While driving my 2007 Infiniti G35 Tuesday June 25, 2019 the vehicle cut off while driving to work and home. Have had no prior problems and it had low miles at purchase. There is a loss of acceleration power and the vehicle hesitates, the steering wheel locks, and vehicle runs with a high idle, and the check engine light stayed on.

Is there a 2005 Infiniti G35 camshaft position sensor recall?

I googled the car’s issues, and learned that Nissan has a recall on 2005 Infiniti G35’s for the replacement of a camshaft position sensor which has been described as causing this loss of power problem. I called Nissan to see if my daughter’s car was on the recall list and was told it was not.

How much does it cost to repair a 2004 Infiniti G35?

The repair totals $425. 00 and I am seeking reimbursement of that amount from Nissan. The contact owns a 2004 Infiniti G35. The contact stated that while driving at various speeds, the vdc, the slip and check engine warning lights illuminated as the engine stalled.

What problems did you have with your G35 in 2004?

I had issues with my 2004 g35. About 120k miles on it. Car would have trouble starting, only way to start it was to give it some gas. After about a few months car would stop accelerating while driving…but would pull over shut off and start up again and good to go. The solution was the replacing the cam shaft sensor.