How do you lengthen a clutch cable?

To lengthen your cable, start by shortening the sheath using the adjuster at the top end. You can likely adjust the first end with just your hand by turning the adjuster near your bike’s lever. Simply turn the adjuster to extend the length of your bike’s clutch cable and create additional slack.

Can you extend a throttle cable?

The throttle extension will extend the throttle cable by 10 inches. The in-line adjuster allows you to fine tune the cable tension and slack.

Are motorcycle clutch cables universal?

Yes you can… all the clutch cables have the same ends… they only vary in length… and you can get good used ones on ebay through Pinwall MC Salvage….

Why do motorcycles have 2 throttle cables?

So why do some motorcycles have two throttle cables? The previous throttle grip arrangement of operating the spring loaded slide mechanism by a single pull cable was found to be inadequate. That’s why, dual or double cable system throttle grip system was invented to favor twin-cylinder motorcycles in particular.

How do I adjust my clutch cable?

To adjust, simply pull up on the clutch cable and loosen the locknut and the adjuster nut slightly. Next, slowly pull up on the clutch cable again. You will feel a point where the clutch fork engages. This is where the clutch cable should be adjusted to.

What happens if my clutch cable is too tight?

3. Excessively tight clutch cable. An excessively tight clutch cable is another symptom of a possible problem with the clutch cable adjuster. If the adjuster binds, or is adjusted too tightly, this will cause the clutch to be slightly disengaged at all times – even when the pedal is not being stepped on.

How thick is a motorcycle clutch cable?

Inner Wire Diameter: The diameter of the inner wire, 1.2mm & 1.5mm commonly used for throttle and choke cables, and 2.0mm, 2.5mm, 3.0mm used on clutch and brake cables.

Where does the clutch cable run through?

Click to expand… Clutch cable moves on the handlebar end. Stock route has a bracket at the top of the speedo housing that the cable runs thru. Mine now runs at the bottom of the speedo housing at the bars. Wires were long enough for internal routing. Many replace the throttle grip sensor with the one piece Screaming Eagle sensor.

Do you offer replacement cables for my Machine?

If we offer replacement cables for your machine and you are changing handle bars and using the stock controls and intake (carburetor or FI system), then in most cases all we’ll need is to know how much longer or shorter than stock you want the new cables to be. When are samples required?

What is the free length of the throttle cable?

Cable free length is the amount of exposed inner wire, and this will most likely have to be changed when the controls or carburation are changed. If you do not already have a cable that works with the non-stock set up, it will be necessary to send us the new throttle and carburetor or FI throttle body so we can determine the correct free length.