How to prevent electrical hazards in the workplace?

How to prevent electrical hazards in the workplace?

Power Cord should be of High quality: Power cord which is being considered to utilize must be of some renown brand,should be of high quality.

  • Installation place: You need to install power strips in such location where air passage should be at best to scatter heat because too much heat may cause short circuits in
  • Avoid overloading in outlets:
  • Inspect Electrical cords:
  • Avoid binding and knotting cables: You need to avoid binding and knotting the wires because it may produce electric shocks which would be a hazard for your workplace.
  • Unused appliances need to be unplugged: Unused electrical items need to be unplugged until for further use.
  • Avoid to maintain by yourself: You don’t need to support this thing by yourself because it can be dangerous for you and it may produce electrical shocks.
  • Licensed electricians: You need to hire licensed electricians who should have proper information and qualification before playing with wires.
  • Don’t route power cords under the carpets: This is not suggested to install power cords under the rugs.
  • Disconnect electrical equipment: If there are electrical equipment is malfunctioning,and you feel terrible smell then disconnect all the electrical equipment which is plugged into a socket on urgent basis.
  • READ:   Can you change ownership of a house with a mortgage?

    What is the basic electrical safety?

    What is a sample checklist for basic electrical safety? Inspect Cords and Plugs. Check extension cords and plugs daily. Eliminate Octopus Connections. Do not plug several items into one outlet. Never Break OFF the Third Prong on a Plug. Replace broken 3-prong plugs and make sure the third prong is properly grounded. Never Use Extension Cords as Permanent Wiring.

    What are OSHA guidelines?

    OSHA standards are mandatory, enforceable rules that must be followed. OSHA guidelines are voluntary recommendations for compliance with general workplace safety and training initiatives where standards have not been defined.

    What are OSHA requirements for electrical work?

    To ensure that an electrical panel can be accessed at all times – during inspection, maintenance or emergency – OSHA has determined that the working space in front of the equipment must be at least 30-inches wide (or the width of the equipment). A clearance of at least 3 feet is required for equipment using 120 to 250 volts.