What is example of knuckle joint?

A knuckle Joint is a mechanical component that is used to join the two components under tensile loads. It is also known as the Forked pin joint. For example Tractor and trolley. The trolley is being attached to the tractor with the help of a knuckle joint.

What are the advantages of a knuckle joint?

Advantages of Knuckle Joint: The Knuckle joint can withstand large tensile loads. It has good mechanical rigidity. It is simple to manufacture and install. It can be easily assembled and disintegrated.

What is knuckle joint in body?

knuckle, the joint of a finger.

Where are Cotter joints used?

Cotter joint is used to connect two rods subjected to axial tensile or compressive loads. Cotter joint is widely used to connect the piston rod and cross head of the steam engine, so as a joint between the piston rod and the tailor pump rod, foundation bolt etc.

Which material is used for knuckle joint?

Knuckle joints are made up of cast iron and stainless steel. With the advancements in the field of polymers, Teflon can be used for knuckle joints also.

Which of the following are parts of knuckle joint?

Following are the main parts of a knuckle joint:

• Two rods.
• Double-eye end or fork end.
• Single eye end.
• Knuckle pin.
• Collar.
• Taper pin.

What are the advantages of knuckle joint over Cotter joint?

FAQ’s on Knuckle joint The main difference between a cotter joint and a knuckle joint is that a cotter joint can withstand compressive as well as tensile loads, whereas, a knuckle joint can withstand tensile load only.

What are finger joints used for?

Finger-joints are used to join short pieces of wood together to form units of greater length. The joint is composed of several meshing wedges or “fingers” of wood in two adjacent pieces and is held together with glue.

Where is the knuckle found in the skeleton?

Skeletal Anatomy These wrist bones connect to 5 metacarpal bones that form the palm of the hand. Each metacarpal bone connects to one finger or a thumb at a joint called the metacarpophalangeal joint, or MCP joint. This joint is commonly referred to as the knuckle joint.

Where is sleeve and cotter joint used?

Sometimes, a sleeve and cotter joint as shown in Fig. 1 and 2, is used to connect two round rods or bars. In this type of joint, a sleeve or muff is used over the two rods and then two cotters (one on each rod end) are inserted in the holes provided for them in the sleeve and rods.

Which of following is a part of knuckle joint?

socket pin joint
Explanation: In rare explanation, two rods with forks and one rod with eye is connected. 4. A knuckle joint is also called socket pin joint. Explanation: A knuckle joint is also called a Forked Pin Joint.

How knuckle joint is manufactured?

A manufacturing method for a knuckle for a vehicle comprises: a step of casting an aluminum socket in a socket binding part of a knuckle(100) at the same time with casting the knuckle in a casting mold; a step of forging the knuckle after casting; a step of trimming the knuckle after forging; a step of heat-treating …