Common questions

What is the total resistance if three resistance of 5 ohm each are connected in parallel?

What is the total resistance if three resistance of 5 ohm each are connected in parallel?

The equivalent resistance of the configuration of the 3 resistors of 5 ohm each is 7.5 ohm.

How do you find the total resistance of a parallel resistor?

You can find total resistance in a Parallel circuit with the following formula: 1/Rt = 1/R1 + 1/R2 + 1/R3 +… If one of the parallel paths is broken, current will continue to flow in all the other paths.

What is the equivalent resistance of two resistors of 5 ohm is connected in parallel?

∴ Equivalent resistance of two resistors of 5 Ω and 10 Ω connected in parallel is equal to 3.33 Ω.

READ:   Do you write meeting minutes in present or past tense?

What is the current in the 5.0 ohm resistor?

The current through the 5-ohm resistor is 2.4 amperes.

What is the total resistance of a 5 ohm resistor and a 15 ohm resistor in series?

C. D. 28. The circuit diagram below represents four resistors connected to a 12-volt source.

How can three resistors of resistances 5 ohm 10 ohm and 15 ohm be connected to give a total resistance of a 20 3 ohm B 18.3 ohm draw the diagrams?

Three resistors are connected in series. The current is directly proportional to the voltage. Current through 10 ohm resistor will remain same that is equal to the total current in the circuit because the resistor is connected in series.

What is the equivalent resistance of two series resistors of 5 ohms that are connected in parallel to two series resistors of 5 ohms *?

5 // 5 = 2.5 ohm.

What is the equivalent resistance of two series resistors of 5 ohms that are connected in parallel to two series resistors of 5 ohms * 2.5 ohms 5 ohms 10 ohms 20 ohms?

READ:   Is minus 3.00 eyesight bad?

What is the equivalent resistance of two series resistors of 5 ohms that are connected in parallel to two series resistors of 5 ohms: 2.5 ohms.

What is a parallel resistance?

Resistors are in parallel when one end of all the resistors are connected by a continuous wire of negligible resistance and the other end of all the resistors are also connected to one another through a continuous wire of negligible resistance. The potential drop across each resistor is the same.