Blog

Why is my Foscam not connecting?

by Author

Why is my Foscam not connecting?

Disable the router’s firewall or change the blocking rules. Check if your Internet link has enough bandwidth. Log in to the device and check the port number it’s using. Log in to the Foscam App and check if the configuration is correct.

How do I reset my Foscam username and password?

The only choice you have is to perform a hard reset. If it is an indoor Foscam camera, you will keep it powered on, and hold the reset button underneath for about 15 seconds. Once it reboots, you can release the hold, and it will restore to the default settings having no password and ‘admin’ as the username.

How do I setup my Foscam wireless IP camera?

Option 1: setup via the Foscam app

  1. Connect your smartphone or tablet to your router’s network.
  2. Download the Foscam app in the App Store or via Google Play.
  3. Start the application.
  4. Create an account via the app.
  5. Scan the QR code on the camera. The app will than find the camera’s information.
  6. Follow the steps in the app.
READ:   How can I increase my mobile charging speed?

How do I reset my Foscam?

To reset a camera, locate the reset button and press it for approximately 30 seconds. At the end of that time the camera will reboot itself and the factory settings will be restored. Some models require only a 10-15 second timeframe.

Why won’t my IP camera connect?

Make Sure There Is No Signal Interference. If there is a bad reach, the IP camera can’t find your WiFi signal, and it cannot connect to the WiFi. The IP camera should not be too far from the router. Check the distance between the IP camera and the router.

What do I do if my P2P status is offline?

Annke Vision – What to Do If P2P Status Shows Offline? (S500…

  1. Make sure the receiver is connected to a router via ethernet cable.
  2. Go to Setting- Network- General, tick on ‘DHCP’ and “Obtain DNS automatically”, then click ‘Apply’.
  3. Go to ANNKE Vision, tick on ‘Enable’.
READ:   Which is better watching TV or reading books?

How do I log into my Foscam camera?

Press the Enter key. The login page for the camera should appear on the browser window. Enter the username and password for the camera. If this is the first time the camera is being logged into the default username is Admin followed by a blank password.

What is my foscam IP address?

In the IP Configuration Window, you can see the camera’s network configuration. Based on the settings in this window you can see some information about the network. Your network may be different. Notice the camera’s IP address is 192.168.

How do I find my Foscam IP address?

To find out the IP address of the Foscam camera follow the steps below.

  1. Connect the camera via an Ethernet cable to a LAN port on the router.
  2. Power on the Foscam camera.
  3. Verify the computer is connected to the same router.
  4. Standby until the camera completes the self-test.
READ:   What is the ratio of blue marbles to red marbles?

How do I factory reset my Foscam r2?

Press and hold the “Reset” button on the camera for about 10 seconds with the camera powered on, and then release. 2. Once the button is released, wait about 30 seconds. The camera will play voice prompts that reset is successful, and then automatically reboot and restore factory settings.